Deck repair
Damaged structure is repaired before any new metal is installed.
Metal Roofing
Metal Roof Replacement Glen Ridge, NJ
When an old metal roof in Glen Ridge leaks in too many places to chase, replacement with new panels usually makes more sense than another round of screws and sealant, after checking the framing and decking underneath. Dial (862) 357-6041 to talk with a local roofer about replacing the roof.
Replacement comes up once rust or wear has spread past what patches and new fasteners can fix. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Older roofs made from thin, lightly coated steel tend to reach that point first.
There are a few ways to replace a metal roof, and the right one depends on what is underneath. A full tear-off removes the old panels and trim so the purlins or deck can be inspected and repaired, then new metal goes on. A re-cover, or retrofit, installs new metal over the old panels on new sub-framing, which is common on shops and large buildings.
A big share of metal replacement work is switching a worn shingle roof to metal. The shingles can come off or, if local code permits and the deck is sound, the metal can go over them. Before calling, note the roof age, the type of panels or shingles on it and where it leaks.
Depending on what the roofer finds, metal roof replacement in Glen Ridge, NJ can go hand in hand with metal roof installation and metal roof repair.
Looking for Glen Ridge metal roof replacement? Call (862) 357-6041 to reach a nearby roofing contractor.
Call nowThe process
The metal roof replacement process
Here is how a metal replacement usually goes.
Assess the old roof
The old roof and the structure beneath it are evaluated for rust, rot and fastener holding power. This decides tear-off, re-cover or partial panel replacement.
Pick the system
The new system is selected, whether exposed fastener or standing seam, and the method of replacement is settled. The new panels are ordered cut to length.
Remove the old roof
The crew unscrews and lifts off the old metal, stacking it for recycling. The roof is never left open overnight.
Restore the deck
The structure is repaired so new fasteners bite into solid wood. New screws in rotten wood would fail within a few seasons.
Put on the new roof
High-temperature underlayment, new trim, panels, closures and flashing go on in order from the eaves up. Snow guards and ventilation are added where needed.
What is included
Parts of a metal reroof
Re-cover option
A retrofit re-cover avoids a tear-off when the structure checks out.
Metal panels
New panels in the chosen profile, gauge and finish replace the old roof.
Old roof removal
Failed panels and trim come off section by section.
Flashing
All new eave, rake, ridge and wall trim in the same finish as the panels.
Related service
Metal Roof Panel Replacement Glen Ridge, NJ
When only a few panels are rusted through or torn, metal roof panel replacement can keep the rest of the roof in service. The damaged panel is unscrewed, the laps on either side are freed and a new panel of the same profile is lapped in and fastened. Standing seam panels can be replaced too, but it takes more work to unseam and reseam the neighbors.
Many Glen Ridge roofs need only a few panels replaced after a storm or a falling limb. The new panels may look brighter until they weather. Too many swaps, and a full reroof is the smarter route.
Related service
Metal Roof Over Shingles Glen Ridge, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Battens or a new underlayment layer go over the shingles, then the metal is fastened into the decking below.
The catch is that the decking stays hidden. A roofer in Glen Ridge should check the attic for rot and soft spots before recommending it, and the shingles must lie flat enough for the panels. Two existing layers or any doubts about the deck mean a tear-off.
Local help
Metal Roof Replacement Near Me
Around Glen Ridge, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. From Glen Ridge out to neighboring towns such as East Orange, North Arlington, Caldwell and Clifton, older metal roofs tend to need full replacement once the coating is gone, and newer houses are adding metal as their shingle roofs wear out, which is why the condition of the purlins and deck drives the plan.
Need metal roof replacement around Glen Ridge? Call (862) 357-6041 for a Glen Ridge roofer who serves the towns around it too.
How the weather here affects roofs around Glen Ridge
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Glen Ridge is busiest after a hard winter and before the next one.
Why call
Why act early
Less damage
Small roof problems caught early usually stay small repairs.
Local knowledge
Roofers in Glen Ridge know the roof types and weather wear common in local homes.
Straight answers
Ask your questions before you agree to anything.
Metal Roof Replacement FAQ
Is old metal roofing recycled?
Removed metal panels are generally recycled. Metal can be melted down and reused, so it rarely goes to the landfill. Ask the roofer how disposal is handled before work starts.
Is it a good idea to put metal over shingles?
Where code permits, metal can go over a single layer of shingles. The upside is skipping tear-off, while the downside is not seeing the decking. A roofer can tell you which option fits your house.
When does a metal roof need replacing instead of repair?
The answer depends on how much of the metal is still sound. Widespread rust-through, failed paint and stripped holes everywhere usually mean new metal. Call (862) 357-6041 to have a roofer check the roof and the structure.
How is a single metal roof panel replaced?
Single panel replacement is common on exposed fastener roofs. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. New panels may look brighter than the old ones at first.
Can a new metal roof go over the old metal roof?
A retrofit, or re-cover, installs new metal over the existing panels using a sub-framing system. The method is popular on commercial buildings and large outbuildings. The structure has to be checked first, since the old roof stays in place and adds weight.
More questions? Call (862) 357-6041
Often needed together
Metal Roof Installation
Metal roof installation built around the right panel, finish and trim for the house, for homes, garages and outbuildings.
Learn moreMetal Roof Repair
Repairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, so the panels keep shedding water for years more.
Learn moreRoof Replacement
A complete new roof from the deck up when repairs no longer make sense, built to current code from the decking out.
Learn moreStanding Seam Metal Roof
Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, with matching trim, closures and snow guards.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof replacement in Glen Ridge, NJ?
Call (862) 357-6041 to talk to a roofer serving Glen Ridge, NJ.