Leak damage repair
Rotted sheathing or framing under leaks is repaired before new roofing goes over them.
Most mobile home roof leaks in Glen Ridge start at panel seams, screw holes or dried sealant around vents, and all of them can be repaired without replacing the roof. One call to (862) 357-6041 reaches a nearby roofer who works on mobile homes.
Leaks on a manufactured home roof tend to follow a predictable pattern. The roof might be metal panels, an EPDM or TPO membrane, or asphalt shingles on a pitched roof, depending on the age and model of the home. On metal roofs, the seams between panels, the screws holding them down and the sealant around vents, skylights and the AC unit are where water gets in.
Small leaks spread fast in a mobile home. Thin ceiling panels stain and bow, insulation gets soaked and the wood framing can start to rot before the leak is obvious. If a ceiling panel bulges with trapped water, a small hole at the low point lets it drain into a bucket, keeping clear of light fixtures, and power to that area should be shut off at the panel if it is safe to reach.
Mobile home roofs are not built to be walked on like a house roof. The trusses run across the width of the home, and stepping between them can dent metal panels, crack the ceiling below or put a foot through the roof. Stay off a wet or icy roof, and look for the data plate inside the home, which shows the roof load the home was designed for.
Mobile Home Roof Repair is often paired with roof coating and metal roof repair, depending on the cause.
Need mobile home roof repair in Glen Ridge? Call (862) 357-6041 to reach a nearby roofing contractor.
Call nowHere is how a roofer usually approaches a mobile home roof repair.
From a ladder and along the truss lines, the roofer checks seams, screws, coating, edges and penetrations. Inside, ceiling stains help point to where water is getting in.
Loose or stripped screws are replaced with larger fasteners that have new rubber washers, and loose panels are fastened down so they stop flexing. Surface rust is wire brushed and primed.
Open seams are covered with seam tape or fabric embedded in coating. Membrane roofs get matching patches and seam repairs instead.
Every roof penetration is resealed, with brittle vent caps or skylight domes replaced. The edge rail around the roof is resealed too.
Many repairs finish with a roof coating that seals pinholes, protects the metal from rust and keeps the home cooler. Coatings need dry weather and a clean surface to bond.
Rotted sheathing or framing under leaks is repaired before new roofing goes over them.
Panel joints are cleaned and resealed to stop drips into the ceiling.
The roof is recoated after repairs which slows rust on metal.
Loose and rusted screws are replaced with gasketed fasteners to close leaks at every screw.
Penetrations get fresh sealant to stop leaks at each opening.
A full mobile home roof replacement is the answer when rust, rot or a worn membrane has spread across the roof. Older metal roofs are often fastened directly over the trusses with insulation below, so replacement can include adding a deck, more insulation and a new membrane or metal roof. Damaged trusses are fixed first.
For mobile home roof replacement in Glen Ridge, the roofer has to plan around light framing and the roof load the home was built for. A permit may be required, and rules for manufactured homes can differ from site-built homes, so the roofer should check local requirements. Done right, the new roof should end the cycle of patching.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. The most common types are a pitched roof over with trusses and shingles or metal, a flat roof over with insulation board and a single ply membrane, and a metal roof over on furring strips. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
For a Glen Ridge mobile home roof over, the roofer checks the walls and trusses, since the new roof adds weight and catches more wind. A pitched roof over changes the structure, so it often needs a permit and engineering, plus solid anchoring for wind. A good roof over ends the seam and screw leaks that plague old metal roofs.
Mobile and manufactured homes in Glen Ridge range from older single and double wides with metal roofs to newer homes with pitched shingle roofs. From Glen Ridge out to East Orange, North Arlington, Caldwell and Clifton, most mobile home roof calls come down to seams, screws and sealant around vents, and storms with strong wind are what loosen fasteners and lift edges.
Need mobile home roof repair around Glen Ridge? Call (862) 357-6041 for a Glen Ridge roofer who serves the towns around it too.
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Glen Ridge is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Glen Ridge know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (862) 357-6041
A seamless coating over a sound but weathered roof, when the roof underneath is still dry and solid.
Learn moreRepairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, so the panels keep shedding water for years more.
Learn moreEPDM rubber roof repairs done with primer, cover tape and lap sealant made for rubber, never with tar or asphalt cement that ruins the rubber.
Learn moreStopping water at the pipe boots, flashing, valleys and nail holes where roofs actually leak, so the stain on the ceiling stops growing.
Learn moreLooking for something else?
See all roofing servicesCall (862) 357-6041 for a local roofer in Glen Ridge and nearby towns.